|
|
Mozilla 1 & Netscape 6 Setup
|
|
Connect Mozilla or Netscape to our software:
- Print out these instructions! After you start following them you won't be able
to scroll this window down to see the rest of these instructions.
- Make sure our software is installed and running. On Windows, our
Icon appears in the Windows Tray.
- Start Mozilla 1 or Netscape 6 and make sure that you are connected to the
Internet and can browse.
- Select "Edit" and "Preferences..." from
Mozilla's or Netscape's top menu, as shown on the right.
The "Preferences" form will pop up, as shown below.
- Click on the icon next to "Advanced".
- Click on "Proxies".
- If "Automatic proxy configuration" is checked, contact your system
administrator to find out if you can use manual proxy configuration.
- If "Manual proxy configuration" is already checked
and there are already entries next to "HTTP"
(and you didn't put the entries there during an earlier attempt to set up your browser for our software,
and the entries aren't either "localhost" or "127.0.0.1" with port "8000"),
then your browser is using a proxy. Cancel the form and
click here for instructions
customized for you.
Otherwise, check "Manual proxy configuration" and continue with these instructions.
- Enter HTTP Address "127.0.0.1" and Port "8000" as shown above.
Note that the address has three "dots" in it!
Do not change the other entries on the form; only change the
entries for HTTP.
- Click "OK" to complete the Preferences form.
- Setup is complete. Your browser is now configured to use the Guidescope service.
Click here to start using the Guidescope service.
|
|
